Hochgeladen von raluc27 am 02.09.2016


Z-REX by muzz64 is licensed under the Creative Commons - Attribution - Non-Commercial - No Derivatives license.


# Summary

Z-REX's (pronounced "Zee - Rex") are small, easy and fun prints of a dinosaur model... with an opening mouth / jaws and teeth that bite.

No support required... just print it with at least 3 shells and 50% or more infill to make the jaws / mouth springy so they open and close.

At standard scale Z-REX's are 125mm long. You can safely uniformly scale them up (as this will increase internal clearances), but scaling them down may result in the mouth / jaws not moving.

Please refer to the images provided and print instructions for additional information... and post photos of your Z-REX's.

Z-REX's work in the same way as my SHARKZ / CROCZ / EAGLEZ etc. These prints can be found at:

'Sharkz': http://www.thingiverse.com/thing:910216

'Ratz' http://www.thingiverse.com/thing:1532944

'Crocz' http://www.thingiverse.com/thing:941177

'Woodpeckerz' http://www.thingiverse.com/thing:1155168

'Eaglez' http://www.thingiverse.com/thing:963892

'Catz' http://www.thingiverse.com/thing:988088

'Scorpionz' http://www.thingiverse.com/thing:1001286

Note: If you like this check out the rest of my fun and practical designs.

# Print Settings

Printer Brand: MakerBot
Printer: MakerBot Replicator (5th Generation)
Rafts: Doesn't Matter
Supports: No
Resolution: Standard / 0.20mm
Infill: 3 or more shells with 50% or more infill

This is an easy print and works great in PLA... not tested in ABS.

Do not use 'any' automated support otherwise your Z-Rex jaws / mouth may not move. Print with at least 3 shells and 50% or more infill to make the jaws / mouth as springy as possible.

# Post-Printing

Train your Z-REX not to bite things it shoudn't!

  Dateiname Heruntergeladen Dateigröße Download
3dModel Thumbnail z-rex.stl 6 508kb

Alle Dateien herunterladen

Alle Dateien in einer Datei komprimiert herunterladen

 Download (143kb)

Kommentare 0

Mehr 3D-Modelle in dieser Kategorie